Commissioning Engineer Tech- AZ

  • Location: Hillsboro, Oregon
  • Type: Direct Hire
  • Job #887

Under the supervision of Project Manager / Senior Manager – Operations, Installation Tech / Commissioning Engineer is responsible for installing and upgrading AMHS equipment in a timely manner.

This position requires both mechanical and electrical troubleshooting skills and the ability to work independently as well as in a team environment without direct supervision. Commissioning Engineer must follow designated installation procedures and safety guidelines established for work areas. This position is required to work overtime, and weekends.


  1. Perform equipment modifications and commissioning
  2. Assist and provide on-the-job training to other employees as well as to contractors or customers
  3. Follow all safety and protocol guidelines and work with safety coordinators
  4. Prepare for paperwork including Pre-Task Plans daily prior to work, commissioning check sheets
  5. Troubleshoot and recover errors
  6. Read mechanical and electrical drawings
  7. Load/install and analyze software and hardware
  8. Conduct running tool performance tests and verify results
  9. Configure tools to specific customer demands
  10. Communicate project progress and take directions from Project Manager to stay on schedule and provide constructive feedback as warranted
  11. Prioritize tasks based on the commissioning check sheets
  12. Communicate work expectations with co-workers on a daily basis and interact with customer regularly



  • Minimum 2 years of technical (mechanical or electrical) experience
    Semiconductor experience

  • SPECIAL REQUIREMENTS (TRAVEL, OVERTIME, physical demands, environment, ETC.)
  • Required to wear a cleanroom uniform and personal protective equipment, and work at height and in confined spaces. Will work in office and fab settings.
  • Working within a diverse environment
  • Use of mechanical and electrical tools
  • Basic mechanical and electrical systems
  • Hex to decimal, binary to decimal conversion

Control Systems (PLC, PC controlled)

  • Robotics
  • Lockout/Tagout
  • Drawing, reading, and understanding schematics
  • Formal training in electrical – electronics, IT or robotics
  • Ability to work independently as well as in a team environment without much supervision
  • Must possess strong attention to detail
  • Require systematic troubleshooting skills and judgment and problem-solving skills to resolve diverse projects
  • Must be willing to learn and be trained and strive to do better
  • Strong oral and written communicate
  • Must be able to work under pressure of customer and Project Manager(s) and complete tasks under tight time frame
  • Must be able to work overtime, weekends and holidays
  • Required to follow and understand work rules and procedures
  • Must follow safety guidelines established for work areas
  • Must be able to exhibit logic and troubleshooting skills
  • Required to travel
  • Must conform at all times to customer’s safety and cleanliness policies to maintain a safe and clean work environment
Attach a resume file. Accepted file types are DOC, DOCX, PDF, HTML, and TXT.

We are uploading your application. It may take a few moments to read your resume. Please wait!